User Tools

Site Tools


sunvox:manual_en

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
sunvox:manual_en [2019/10/14 07:58]
nightradio [Timeline]
sunvox:manual_en [2019/12/31 10:52] (current)
nightradio [Modes]
Line 573: Line 573:
  
 Some modules have a "​Mode"​ parameter with the following possible values: Some modules have a "​Mode"​ parameter with the following possible values:
-  * HQ - High Quality (stereo). Linear interpolation +  * HQ - High Quality (stereo); 
-  * HQmono - High Quality (mono). Linear interpolation +  * HQmono - High Quality (mono); 
-  * LQ - Low Quality (stereo) for devices with slow CPU +  * LQ - Low Quality (stereo) for devices with slow CPU; 
-  * LQmono - Low Quality (mono) for devices with slow CPU +  * LQmono - Low Quality (mono) for devices with slow CPU; 
-  * HQspline - High Quality (stereo). Spline ​interpolation+  * HQspline - High Quality (stereo) ​with spline ​interpolation.
  
 If the CPU of your device is too slow for some SunVox project (app stutters and hangs), you can use the following tips: If the CPU of your device is too slow for some SunVox project (app stutters and hangs), you can use the following tips:
   * use monophonic modes (Mono, HQmono or LQmono) for the modules;   * use monophonic modes (Mono, HQmono or LQmono) for the modules;
   * use low quality modes (LQ or LQmono) for the modules;   * use low quality modes (LQ or LQmono) for the modules;
-  * use reduced polyphony for generators;​ +  * use reduced polyphony for the generators;​ 
-  * don't use the Reverb, or use it in LQ mode with All-pass filter ​disabled;+  * don't use the Reverb, or use it in LQ mode (Mode = LQ; All-pass filter ​= OFF);
   * use the Filter instead of the Filter Pro;   * use the Filter instead of the Filter Pro;
-  * use the Sampler without ​interpolation (Sample interpolation = OFF; Volume interpolation = OFF); +  * Sampler: turn off the interpolation (Sample interpolation = OFF; Volume interpolation = OFF); 
-  * if possible, use the Generator and Analog Generator ​without Attack and Release (Attack = 0; Release = 0; Sustain = ON); +  * Analog Generatordon't enable the filter ​when the polyphony is greater ​than 2; instead, use the single Filter module ​connected to the output of the generator;​ 
-  * don't enable the filter ​inside ​the Analog Generator if polyphony is higher ​than 2; instead, use the single Filter module ​at the output of the generator;​ +  * Glide, Sound2Ctl, MultiCtl: ​don't use the Sample rate greater than 150 Hz.
-  * don't use Sample rate greater than 150 in the Glide and the Sound2Ctl modules.+
 ===== Timeline ===== ===== Timeline =====
  
sunvox/manual_en.1571029102.txt.gz · Last modified: 2019/10/14 07:58 by nightradio