SunVox song optimization for slow devices

Post Reply
User avatar
NightRadio
Site Admin
Posts: 3157
Joined: Fri Jan 23, 2004 12:28 am
Location: Ekaterinburg. Russia
Contact:

SunVox song optimization for slow devices

Post by NightRadio » Sat Dec 08, 2012 4:56 pm

The CPU of your device is too slow for some SunVox project? Here are some tips to avoid this.
  • Use monophonic modes (Mono, HQmono or LQmono) for the modules.
  • Use low quality modes (LQ or LQmono) for the modules.
  • Use reduced polyphony for generators.
  • Don't use the Reverb, or use it in LQ (Low Quality) mode and with All-pass filter disabled.
  • Use the Sampler without interpolation (Sample interpolation = OFF; Volume interpolation = OFF).
  • Use the Generator without Attack and Release (Attack = 0; Release = 0; Sustain = ON).

bournio
Posts: 5
Joined: Wed Dec 05, 2012 7:20 pm

Re: SunVox song optimization for slow devices

Post by bournio » Sun Dec 23, 2012 1:56 am

I can't test this out at the moment, but does controlling velocity towards the end of a note use less CPU than the Release control?

User avatar
NightRadio
Site Admin
Posts: 3157
Joined: Fri Jan 23, 2004 12:28 am
Location: Ekaterinburg. Russia
Contact:

Re: SunVox song optimization for slow devices

Post by NightRadio » Mon Dec 24, 2012 9:51 pm

but does controlling velocity towards the end of a note use less CPU than the Release control?
Yes, but only if your generator has no envelope (attack = 0 and release = 0).

Post Reply