- Posts: 1
- Joined: Fri Mar 27, 2020 6:02 pm
When I click on an Analog Generator in SunVox most of them seem to have 19 properties:
- 01 - Volume
02 - Waveform
03 - Panning
04 - Attack
05 - Release
06 - Sustain
07- Exponential Envelope
08 - Duty Cycle
09 - Freq2
0A - Filter
0B - F. freq (Hz)
0C - F. resonance
0D - F. exponential freq
0E - F. attack
0F - F. release
10 - F. envelope
11 - Polyphony (ch.)
12 - Mode
13 - Noise
I don't see anywhere in that generator where I can adjust the Fundamental (or Base) frequency of the tone without changing the MIDI note.
If I want to apply a Pitch Bend in SunVox, is it correct that I am supposed to connect the Misc. - Glide or Effects - Pitch shifter modules to the generator and use them? If so which one is best? In the short term I want to sweep from one note to the next in small subsections of a note pattern.
I am not using a MIDI controller at this time. Everything is entered "by hand" using a computer keyboard and mouse.
- Posts: 321
- Joined: Mon Mar 21, 2016 9:41 am
- Location: N. Tulsa Ok.
From the manual:
01 - slide up (portamento up; sliding speed = XXYY);
02 - slide down (portamento down; sliding speed = XXYY);
03 - slide to note (sliding speed = XXYY);
04 - vibrato; (XX - frequency; YY - amplitude);
these commands work on the analog generator, the generator and the sampler. I think they also work on the Vorbis player, not sure. they also work on the Multisynth or Glide that would control other modules.
the Glide is a good option, it has the ability to control the rate at which a note slides to the next. you can do some neat tricks from fast pitch decay (like on a bassdrum) or vibrato. best thing to do is just play around with the commands above and try out the Glide. usually for a bass-line my chain goes like this:
hope this helps.