Switch?
Re: Switch?
something can redirect connection between modules to reduce the amount of modules in project? My plan is to use one reverb module only if needed due to its amount of cpu used.
If not, i leave this as a feature request, which have its controllers this way:
-00: Input module (00-FF)
-01: Output module (00-FF)
-Input module name: <module name shown>
-Output module name: <module name shown>
If not, i leave this as a feature request, which have its controllers this way:
-00: Input module (00-FF)
-01: Output module (00-FF)
-Input module name: <module name shown>
-Output module name: <module name shown>
Re: Switch?
up until now a Meta modul containing two moduls both connected to its meta output can be targeted by the input parameter of the Meta modul. That way you basically select the chain which shall "receive" the audio buffer or events, which in turn represents a switch. Another question is if there can be logic inside such Meta modul to decide which route to take. But this method does not turn off (mute/bypass) the reverb, it just targets the modul you want inside that meta.
Re: Switch?
I’ve been wondering if the round robin option introduced to multisynth in v 2 can be exploited to do something like this with more control.. I’ve so far only used it in fairly loose ways that don’t require being too precise