Page 1 of 1

SpectraVoice incoherence

Posted: Thu Apr 15, 2021 11:18 pm
by freealise
While trying to control the SpectraVoice harmonic frequencies with the automation curve and looking at the spectral analyzer, I've noticed that they depend on the base note but the displayed frequency doesn't change with the change of note.

Re: SpectraVoice incoherence

Posted: Fri Apr 16, 2021 10:13 am
by NightRadio
but the displayed frequency doesn't change with the change of note.
If you mean the value of the H.freq controller - it always shows the frequency for note c6.
SpectraVoice is a sampler. When you change the H.freq, it re-renders the internal sample (with base note c6)

Re: SpectraVoice incoherence

Posted: Sat Apr 17, 2021 12:15 am
by freealise
Thanks for clarification :)
I would never think of it as a sampler, though you were probably saving on processing power.

Re: SpectraVoice incoherence

Posted: Sat Apr 17, 2021 2:59 pm
by burij
When I add a new SpectraVoice Module it has Relative Note +4 in the property Settings. Is it on purpose?

Re: SpectraVoice incoherence

Posted: Sun Apr 18, 2021 1:25 pm
by NightRadio
When I add a new SpectraVoice Module it has Relative Note +4 in the property Settings. Is it on purpose?
Initially, the SpectraVoice did not sound in tune with the rest of the built-in synthesizers. It happened by mistake.
Therefore, the Relative Note is set to +4 so that the SpectraVoice sounds the same with other modules.

Re: SpectraVoice incoherence

Posted: Sun Apr 18, 2021 3:25 pm
by burij
Ok, thanks!