Page 1 of 1

Changing Sample Unroutes The Generator

Posted: Mon Jul 02, 2018 10:19 am
by hseiken
Hi, I was jamming and recording my jam session and found a possible bug. Basically, I loaded up a sample in a sampler and the sampler disconnected itself from the output after loading a new sample on one that was already loaded.

I've left a link here with a timestamp. It's not a terrible bug, but it might confuse people who are unaware this occurs, it certainly confused me as you can detect in the screencast.

Sorta related; the situation that had me reload the sample was because there was no undo for the cut operation at least that I could find/invoke. Like most things, I tend to not see what's in front of my face half the time. That said, CTRL+Z is mapped to undo and even with focus on the sample editor, I got no response. I know undo operations on sampling can take up a bit of memory in some cases so it's understood if this is omitted due to device compatibility/memory concerns.


Re: Changing Sample Unroutes The Generator

Posted: Sat Jul 07, 2018 10:34 pm
by NightRadio
You cut some piece of sample -> you press CTRL+Z out of habit -> Sampler has no support of UNDO/REDO, so it retransmits CTRL+Z message to the parent window -> parent window (sound network) successfully processes the UNDO message and cancels the previous action "make connection between the Output and Sampler" :roll:

Re: Changing Sample Unroutes The Generator

Posted: Sun Jul 08, 2018 3:22 pm
by hseiken
Ahh, this makes sense. Thanks!