Page 1 of 1

Audiobus

Posted: Thu Jan 02, 2014 10:38 pm
by MelS
I recently tried to connect the app Thor Synthesizer to SunVox via Audiobus and it shows SunVox as an effect instead of an output.
I'm not sure if it is a bug or if it is intended to do that.
I just think it would be good to be able to play stuff in another app (like Thor) and record the sound on SunVox. Gives you more possibilities with instruments.
Using the latest version of iOS, Thor, Audiobus and SunVox. iPad 4th gen

Re: Audiobus

Posted: Fri Jan 03, 2014 12:32 pm
by NightRadio
It is not a bug. SunVox can be only in the INPUT and EFFECTS slots. OUTPUT slot it not supported due to some technical problems.
When in the EFFECTS, you should use the Input module to get the input signal. You can record it, change it (apply effects), or/and send directly to the Output.

Re: Audiobus

Posted: Fri Jan 03, 2014 7:55 pm
by MelS
NightRadio wrote:It is not a bug. SunVox can be only in the INPUT and EFFECTS slots. OUTPUT slot it not supported due to some technical problems.
When in the EFFECTS, you should use the Input module to get the input signal. You can record it, change it (apply effects), or/and send directly to the Output.
Tried that, only got Mic results in the Sampler on SunVox and no sound was coming out of Thor.

Re: Audiobus

Posted: Sat Jan 04, 2014 11:51 am
by NightRadio
Hm... It is very strange, because it works on my iPad1 without problems.
AudioBus INPUT: VirtualANS.
AudioBus EFFECTS: SunVox with the following chain: Input -> Echo -> Output.
AudioBus OUTPUT: Speaker Output.