Page 1 of 1
Accurate LFO Phase
Posted: Mon Jul 10, 2017 8:38 am
by Trickle
I noticed that the phase in SunVox's LFO "slides" when it oscillates. The LFO always starts on a new phase whenever a note ends or begins. So, is there a way to accurately start, and end, on the same phase? or is there a way to work around this?
Re: Accurate LFO Phase
Posted: Mon Jul 10, 2017 2:02 pm
by NightRadio
The LFO always starts on a new phase whenever a note ends or begins.
Exactly, because the LFO phase is independent parameter :) It never stops.
Use the "Set phase" controller to change the phase value.
Re: Accurate LFO Phase
Posted: Tue Jul 11, 2017 3:12 am
by Trickle
Hmm, how do I use this "Set phase" controller? I'm not too familiar with this controller on the LFO module, so can you briefly explain its usage? Thanks for the speedy reply.
Re: Accurate LFO Phase
Posted: Tue Jul 11, 2017 1:29 pm
by NightRadio
Just set it :)
For example, in some line of the pattern, change the "Set phase" controller to some value. For example, to 128:
Then play this pattern. And the line (described above) will reset the phase of your LFO to 128.
Min phase value is 0. Max is 256.
Re: Accurate LFO Phase
Posted: Thu Jul 13, 2017 6:21 am
by Trickle
Ah, I see. Thanks for the extra help. I think I understand the SunVox LFO a bit better now. Thanks again, NightRadio.