Grab the sunsynths at https://github.com/metrasynth/gallery/t ... explfosive
ExpLFOsive for SunVox
ExpLFOsive is a set of exponential LFO MetaModules.
Choose anywhere from 2 to 16 LFOs, and you will have the power to construct a wide range of useful curves beyond the standard ones provided by SunVox.
How to use it
Use it in place of a standard LFO set to generator mode.
Change the all.* controllers to affect all LFOs.
Change the lfo_[0-15].* controllers to affect individual LFOs in the series.
SunVox LFO rules still apply, so when you change the waveform or set_phase of an individual LFO, it will become out of sync with the rest of the LFOs.
As with a single LFO, resync all LFOs by sending any note to the ExpLFOsive module. This will cause them all to immediately set their phase to whatever value set_phase is currently at for each
As a traditional LFO
Use it to drive a Sound2Ctl module to create exponential curves for filter sweeps, velocity changes, or whatever your imagination likes.
Use it as the modulator signal (second input) to a Modulator module to create interesting amplification envelopes, or to create weird FM wobbles.
As a sound source
Change controller 0B (all.frequency_unit) to 2 ("Hz" mode).
Then, change controller 08 to set pitch.
If you want to manipulate it with notes, set up a Pitch2Ctl module, set its OUT controller to 8, then connect it to the ExpLFOsive module.
How it works
It is implemented as a series of LFOs whose phase and controller values are kept in sync.
Each LFO acts as a multiplier for the previous in the series.
The more LFOs there are in series, the stronger the exponentiation will be.
2 posts • Page 1 of 1